Length: 10cm
Type: Female
Suitable for: Tiny Drone power supply/ 2s battery cable extend/for ESC/ for Section Board Soldering and many morePackage
1x XT30 Connector with 10cm long cable
❓ Preguntas Frecuentes
Is this product compatible with my drone?
This component follows market standards. Check whether you use an analog or digital (HD) system and your battery voltage.
When will it arrive?
If you buy now, we ship within 24h from our warehouse in Spain.
Preguntas Frecuentes (FAQ)
Q: What is the maximum current this XT30 connector with 10cm cable can safely handle?
A: The XT30 connector is typically rated for 30A continuous current. However, the actual capacity will depend on the gauge of the wire used. This 10cm cable usually comes with 14AWG wire, making it suitable for most FPV drone applications with 2S and 3S batteries, but we recommend checking the maximum current of the specific cable to avoid overheating or damage.
Q: Is this female XT30 connector with 10cm cable suitable for connecting a LiPo battery directly to an ESC (Electronic Speed Controller) on a Tiny Whoop or similar drone?
A: Yes, this connector is ideal for connecting a LiPo battery to an ESC on Tiny Whoop or similar drones. The 10cm length is practical for these compact setups. Make sure to solder the wire to the ESC and battery correctly, observing the right polarity (red positive, black negative) to avoid damage.
Q: What type of solder is recommended for connecting this XT30 cable to a distribution board or ESC, and what precautions should I take?
A: We recommend using tin solder with flux for electronics, preferably with a thin diameter (0.8mm or similar) to make precise application easier. When soldering, make sure to pre-tin both the wire and the board pads for better adhesion. Avoid overheating the components, as this can damage them. Use tweezers or a holder to keep the wire in place during soldering and make sure the joint is solid and shiny.
Reviews
There are no reviews yet