Foxeer F722 V3 Mini Flight Controller 20x20mm

/*! elementor – v3.13.2 – 11-05-2023 */
.elementor-widget-image{text-align:center}.elementor-widget-image a{display:inline-block}.elementor-widget-image a img[src$=».svg»]{width:48px}.elementor-widget-image img{vertical-align:middle;display:inline-block}

Preguntas Frecuentes (FAQ)

Q: What type of ESC telemetry does the Foxeer F722 V3 Mini support and how can I set it up to get accurate telemetry data?
A: The Foxeer F722 V3 Mini supports ESC telemetry through the RX4 port. To set it up, make sure your ESC's telemetry protocol (for example DShot600, DShot300, Multishot) is correctly configured in Betaflight. In the Betaflight configuration, select the RX4 port as the ESC telemetry port and make sure the communication speed (baud rate) matches your ESC's setting. Also check that the wiring is correct, connecting the ESC's telemetry wire to the flight controller's RX4 pin.

Q: The Foxeer F722 V3 Mini has a 20x20mm mounting size. Is it compatible with all FPV frames of that size, or are there additional considerations I should keep in mind?
A: Although the mounting size is 20x20mm, it is important to check the available height in your frame. The Foxeer F722 V3 Mini measures 26x26mm, so you will need enough vertical space inside the frame to fit the flight controller, plus connectors and cables. Also make sure the frame's mounting holes are compatible with the flight controller's Φ4mm holes. Some frames may have nearby components that interfere with the controller, so check the available space carefully before installation.

Q: What does the DC5V/3A BEC output mean and how can I use it to power other components on my FPV drone?
A: The DC5V/3A BEC (Battery Eliminator Circuit) output provides a regulated 5V power supply with a maximum capacity of 3 amps. This lets you power components that require 5V, such as the FPV camera, the receiver or the VTX (Video Transmitter), directly from the drone's battery, removing the need for separate batteries for these components. It is important not to exceed 3A of total current to avoid damaging the BEC. If you need to power components that draw more than 3A, you will need to use an additional Power Distribution Board (PDB).