Description
Pre-crimped SH1.0 cables with connectors
With this SH1.0 cable kit you can make any lead for your drone just by pushing the terminals into the housing, no crimping tool needed. You can order the colours however you like to connect your flight controller to the camera, VTX, GPS, receiver or a telemetry module.
The wires are very soft silicone that stays flexible in the cold and does not pass vibration to the flight controller. They are also handy for replacing a broken lead on the spot at the field.
SH1.0 cable kit contents
- 240 pre-crimped 15 cm SH1.0 wires, 40 in each of 6 colours
- 20 housings each of 3, 4, 5, 6 and 7 pins
- 10 housings each of 8, 9, 10 and 12 pins
- 100 heat shrink tubes, 1 mm
- 1 pair of tweezers
How to make a lead
Check each board’s manual for which signal goes on each pin. Push the terminal into the housing with the tweezers until it clicks. To join two wires at the other end, solder and cover with heat shrink.
Frequently asked questions about SH1.0 cables
Do I need a crimping tool?
No, the wires come with the terminal already crimped; you just push them in.
Which boards use SH1.0?
Many F4 and F7 flight controllers, such as the Omnibus, plus GPS units, VTXs and cameras.
Reviews
There are no reviews yet