The frame is the skeleton. It sets the prop size and where you bolt the flight controller.
Almost everything comes integrated (AIO). HD is not recommended because of the weight.
Approximate prices · Guidance only; always check the manufacturer's spec sheet.
HelpIndoors, learning, fun. Almost everything comes integrated (AIO). HD is not recommended because of the weight.
| Props | 31–40 mm |
|---|---|
| Motors (stator) | 0702, 0802, 1102, 1103 |
| Recommended KV | 18000–26000 KV on 1S |
| Battery cells | 1S |
| Battery capacity | 1S: 300–850 mAh |
| ESC (amps) | 5–12 A |
| Flight controller bolt pattern | AIO integrada (25.5x25.5 o 16x16) |
| Weight without battery | 20–35 g |
| Approximate cost | 70–140 € |
| Build time | 2–4 h (beginner) · 1–2 h (experienced) |
The usual is 0702, 0802, 1102 or 1103 motors, with 18000–26000 KV on 1S. A motor that's too small runs out of power and one that's too big adds weight.
It uses 1S. Typical capacities: 1S 300–850 mAh. The battery cells must match the motors and what the ESC supports.
The drone costs roughly between €70 and €140. On top of that you need a radio, goggles and a charger if you don't have them.
A beginner takes about 2–4 hours; someone with experience, 1–2 hours.
Analog will fit. Remember the goggles must use the same system as the camera.
Indoors, learning, fun. Almost everything comes integrated (AIO). HD is not recommended because of the weight.
Complete builds ready to customise.
