The frame is the skeleton. It sets the prop size and where you bolt the flight controller.
20x20 and 25.5x25.5 are the usual; some 3" frames use 30x30. Cinewhoops use 2004 motors and 850-1300 mAh. HD adds a lot of weight.
Approximate prices · Guidance only; always check the manufacturer's spec sheet.
HelpFilming near people, indoors, light flying. 20x20 and 25.5x25.5 are the usual; some 3" frames use 30x30. Cinewhoops use 2004 motors and 850-1300 mAh. HD adds a lot of weight.
| Props | 3" |
|---|---|
| Motors (stator) | 1303, 1404, 1407, 1506, 1507, 1606, 2004 |
| Recommended KV | 4500–5500 KV on 2S · 4000–5000 KV on 3S · 3000–4200 KV on 4S · 2500–3000 KV on 6S |
| Battery cells | 2S, 3S, 4S, 6S |
| Battery capacity | 2S: 550–650 mAh · 3S: 550–850 mAh · 4S: 450–1300 mAh · 6S: 550–1300 mAh |
| ESC (amps) | 25–45 A |
| Flight controller bolt pattern | 20x20, 25.5x25.5, 30.5x30.5 |
| Weight without battery | 70–300 g |
| Approximate cost | 150–320 € |
| Build time | 5–8 h (beginner) · 2.5–4 h (experienced) |
The usual is 1303, 1404, 1407, 1506, 1507, 1606 or 2004 motors, with 4500–5500 KV on 2S or 4000–5000 KV on 3S or 3000–4200 KV on 4S or 2500–3000 KV on 6S. A motor that's too small runs out of power and one that's too big adds weight.
It uses 2S or 3S or 4S or 6S. Typical capacities: 2S 550–650 mAh, 3S 550–850 mAh, 4S 450–1300 mAh, 6S 550–1300 mAh. The battery cells must match the motors and what the ESC supports.
The drone costs roughly between €150 and €320. On top of that you need a radio, goggles and a charger if you don't have them.
A beginner takes about 5–8 hours; someone with experience, 2.5–4 hours.
Analog, DJI O4, Walksnail Avatar or HDZero will fit. Remember the goggles must use the same system as the camera.
Filming near people, indoors, light flying. 20x20 and 25.5x25.5 are the usual; some 3" frames use 30x30. Cinewhoops use 2004 motors and 850-1300 mAh. HD adds a lot of weight.
Complete builds ready to customise.
