The frame is the skeleton. It sets the prop size and where you bolt the flight controller.
Everything integrated on an AIO board. On 1S and 2S it's ideal indoors; on 3S-4S it flies outside. Typical weight 30-130 g.
Approximate prices · Guidance only; always check the manufacturer's spec sheet.
HelpMicro for indoors and parks, very light. Everything integrated on an AIO board. On 1S and 2S it's ideal indoors; on 3S-4S it flies outside. Typical weight 30-130 g.
| Props | 2" |
|---|---|
| Motors (stator) | 1002, 1003, 1102, 1103, 1105, 1106 |
| Recommended KV | 20000–23000 KV on 1S · 10000–14000 KV on 2S · 6000–8000 KV on 3S · 5000–6000 KV on 4S |
| Battery cells | 1S, 2S, 3S, 4S |
| Battery capacity | 1S: 450–650 mAh · 2S: 450–650 mAh · 3S: 300–450 mAh · 4S: 450–650 mAh |
| ESC (amps) | 5–20 A |
| Flight controller bolt pattern | AIO 16x16 |
| Weight without battery | 30–130 g |
| Approximate cost | 90–200 € |
| Build time | 3–6 h (beginner) · 1.5–3 h (experienced) |
The usual is 1002, 1003, 1102, 1103, 1105 or 1106 motors, with 20000–23000 KV on 1S or 10000–14000 KV on 2S or 6000–8000 KV on 3S or 5000–6000 KV on 4S. A motor that's too small runs out of power and one that's too big adds weight.
It uses 1S or 2S or 3S or 4S. Typical capacities: 1S 450–650 mAh, 2S 450–650 mAh, 3S 300–450 mAh, 4S 450–650 mAh. The battery cells must match the motors and what the ESC supports.
The drone costs roughly between €90 and €200. On top of that you need a radio, goggles and a charger if you don't have them.
A beginner takes about 3–6 hours; someone with experience, 1.5–3 hours.
Analog, DJI O4 or Walksnail Avatar will fit. Remember the goggles must use the same system as the camera.
Micro for indoors and parks, very light. Everything integrated on an AIO board. On 1S and 2S it's ideal indoors; on 3S-4S it flies outside. Typical weight 30-130 g.
Complete builds ready to customise.
