Description
8-in-1 charger cable for RC batteries
This 8-in-1 charger cable plugs into the 4 mm banana output of your LiPo charger and gives you eight different connectors. That way you can charge drone, plane or RC car batteries without a separate lead for each one.
It is made with red and black silicone wire that stays flexible even in the cold. It can also power the glow plug of methanol engines and other gear that uses one of these connectors.
8-in-1 charger cable connectors
- Input: 4 mm bananas
- Male T-Dean
- Female XT60
- Female Futaba
- Male JST
- Male Tamiya
- Male TRX
- Two free leads to solder on the connector you need
- Length: 150 mm main lead plus 150 mm branches, 300 mm in total
How to use it safely
Connect only one battery at a time: the outputs are wired in parallel and two batteries at once would discharge into each other. Set the correct battery type and cell count on the charger and, with LiPos, always charge through the balance lead too.
Frequently asked questions about the 8-in-1 charging cable
Does it work with any charger?
With any charger that has a 4 mm banana output, which is standard on hobby LiPo chargers.
What are the free leads for?
To solder on a connector that is not among the seven, such as an XT30, if you need one.
Reviews
There are no reviews yet