Description
8 cm XT60 to XT30 adapter
This XT60 to XT30 adapter is a short 8 cm lead with a male XT60 on one side and a female XT30 on the other. It lets you connect a drone, battery or any XT30 device to a lead, charger or power supply that only has XT60.
It is very handy on the bench and in the field: with a single XT60 charging lead you can also charge the small XT30 batteries of micro drones and toothpicks, without cutting or soldering anything.
XT60 to XT30 adapter specifications
- End 1: male XT60
- End 2: female XT30
- Length: 8 cm
- Wire: 5 cm, 16 AWG
- Contents: 1 adapter cable
Before using it
The XT30 connector is rated for lower currents than the XT60. Use it for charging or powering small devices, not for flying a large drone from an XT60 battery. Always check polarity, red to red and black to black, before plugging in.
Frequently asked questions about the XT60 to XT30 adapter
Can I charge XT30 batteries with it?
Yes, if your charger lead ends in XT60. Remember to also connect the battery’s balance lead to the charger.
How long is it?
5 cm of cable between the two connectors.







Reviews
There are no reviews yet