IFlight BLITZ E80 Single ESC
PRODUCT DESCRIPTION
The BLITZ E80 BLHeli Dshot600 Single ESC has been designed to give your motors smooth power with great stability and durability. The 32-bit 48mHz G071 MCU and 11 TDK MLCC capacitors totaling 240UF of low ESR deliver a faster response and a smoother flying experience.
Characteristics:
– 2-8S input (maximum 8S)
– 80A copper PCB, 8 layers and 4OZ, better operating load capacity;
– 11 TDK MLCC capacitors totaling 420UF of low ESR, lower ripple and greater stability;
– High-quality NTMFS5C430NL MOSFET, stable and reliable;
– 1 3528 LED to indicate power on;
– Rational design, wide solder pads, countersinks and semicircular holes allow each layer to be energized after power-on.
Specification:
– Dimension: 40*17mm
– Peso: 9.5g(±2g)
– Supports 2-8S LiPo input
– MCU STM32G071, 48Mhz Ejecuta Firmware BLHELI 32.X
– Capacitance: total 240UF of low ESR
– Telemetry output
– BEC: No
– Soporta: DShot DShot150/300/600/MultiShot/OneShot PWM Drive
– Objetivo: IFLIGHT_BLITZ_G2
– BLHeliSuite download:https://github.com/blheli-configurator/blheli-configurator/releases
Soporte:
– Current sensor
– Telemetry output
– Motor timing
– Brake on stop
Included in the package:
– BLITZ E80 Single ESC *1 unidad
– 50V 470UF capacitor * 1 unit
– Cables and ESC signal wires *1 set
❓ Preguntas Frecuentes
Is this product compatible with my drone?
This component follows market standards. Check whether you use an analog or digital (HD) system and your battery voltage.
When will it arrive?
If you buy now, we ship within 24h from our warehouse in Spain.
Preguntas Frecuentes (FAQ)
Q: Which communication protocols does the iFlight BLITZ E80 support and which is recommended for optimal FPV performance?
A: The iFlight BLITZ E80 supports DShot (DShot150/300/600), MultiShot and OneShot PWM. For optimal FPV performance, we recommend using DShot600. This digital protocol offers higher precision, lower latency and is less susceptible to interference than analog PWM protocols, resulting in a faster, more consistent motor response.
Q: The ESC has no BEC. How is the FC (Flight Controller) powered in a setup that uses this ESC?
A: The iFlight BLITZ E80 does not include a BEC (Battery Eliminator Circuit). This means the FC must be powered directly from the main battery (LiPo) through a Power Distribution Board (PDB) or by connecting the FC directly to the battery power pads on the ESC (if it has them). It is crucial to verify that the battery voltage is compatible with the FC.
Q: What is the total capacitor capacity and how does it affect ESC performance, especially in high-current situations?
A: The iFlight BLITZ E80 has 11 TDK MLCC capacitors totaling 240uF of low ESR (Equivalent Series Resistance). This high capacitance helps stabilize voltage and reduce ripple during current demand peaks, such as rapid acceleration or aggressive maneuvers. This translates into cleaner, more reliable motor performance, avoiding unexpected cutouts or failures.
Reviews
There are no reviews yet