Description
XT60H male 14AWG with 10 cm of wire
This XT60H male 14AWG connector comes pre-soldered to 10 cm of red and black silicone wire, with tinned ends ready to solder. You skip the trickiest part, soldering the connector, and only need to join the ends where you need them.
This is the XT60H version: a grey housing covers the connector's solder joints and makes it easier to grip when plugging and unplugging.
14AWG wire is a little thinner and more flexible than 12AWG. It suits 3- and 4-inch drones, charging leads, adapters and builds where the wire has to bend in a tight space. The 10 cm of wire leaves room to place the connector where you want and trim the rest.
XT60H male 14AWG specifications
- Connector: XT60H male
- Housing: grey, over the solder joints
- Wire: 14AWG silicone, red and black
- Wire length: 10 cm
- Ends: tinned, ready to solder
- Contents: 1 connector with wire
Male or female
The male has the pins and the female has the sockets: one always plugs into the other. Before cutting anything, check which connector your battery, drone or charger has and choose the opposite one.
Soldering tips
Mind the polarity: red is positive and black is negative. Tin the wire you are joining it to as well, solder quickly so the silicone does not overheat, and cover each joint with heat shrink.
XT60H male 14AWG FAQ
What does it plug into?
An XT60 female. XT60 and XT60H plug into each other: the housing does not change the mating part.
How much wire does it have?
10 cm of silicone wire pre-soldered to the connector, with tinned ends.
Is it OK for a 5-inch drone?
A 5-inch battery lead usually uses 12AWG. 14AWG suits smaller gear, chargers and adapters better.
Reviews
There are no reviews yet