Description
XT60 female 12AWG with 10 cm of wire
This XT60 female 12AWG connector comes pre-soldered to 10 cm of red and black silicone wire, with tinned ends ready to solder. You skip the trickiest part, soldering the connector, and only need to join the ends where you need them.
This is the classic XT60 without a housing: a compact connector with a yellow body and XT60 moulded into the plastic.
12AWG wire is the usual gauge for the battery lead on 5-inch and larger drones: more copper and less voltage drop when the drone pulls a lot of current. The 10 cm of wire leaves room to place the connector where you want and trim the rest.
XT60 female 12AWG specifications
- Connector: XT60 female
- Wire: 12AWG silicone, red and black
- Wire length: 10 cm
- Ends: tinned, ready to solder
- Contents: 1 connector with wire
Male or female
The male has the pins and the female has the sockets: one always plugs into the other. Before cutting anything, check which connector your battery, drone or charger has and choose the opposite one.
Soldering tips
Mind the polarity: red is positive and black is negative. Tin the wire you are joining it to as well, solder quickly so the silicone does not overheat, and cover each joint with heat shrink.
XT60 female 12AWG FAQ
What does it plug into?
An XT60 male. XT60 and XT60H plug into each other: the housing does not change the mating part.
How much wire does it have?
10 cm of silicone wire pre-soldered to the connector, with tinned ends.
Is it OK for a 5-inch drone?
Yes: 12AWG is the gauge normally used for the battery lead on a 5-inch.
Reviews
There are no reviews yet