PCB holder for repairing flight controllers and boards

Description

PCB holder for flight controllers and boards

This PCB holder keeps flight controllers, ESCs, PDBs and any small board in place while you solder or replace a component. It is carbon steel, 8 × 12 cm, with three sliding clamps to set the board in the best position.

The board sits flat and firm, so you can solder small pads, replace a capacitor or desolder a connector without it moving. It is a universal holder, the same kind used to repair phone boards.

PCB holder specifications

• Material: carbon steel
• Size: 8 × 12 cm
• Clamps: 3 movable, screw-adjusted
• Contents: 1 holder, no boards

How to fit the board

Clamp one side of the board first and then the other, tightening the screw just enough to stop it moving. If you are removing a chip or component with heat, rest the holder on the table so you can work with both hands.

Frequently asked questions about the PCB holder

Does it fit 20 × 20 mm flight controllers?

Yes, the clamps close in enough for small boards and open up for 30.5 mm boards and 4-in-1 ESCs.

Does it include a board?

No, just the holder.

More for your drone

• Soldering stands
• Tools and accessories
• Flight controllers
• FPV guides